SPC wall panels can indeed be bent into a 90-degree right angle, but this requires a precise process. By grooving the backside, heating to soften the material, and then bending carefully, the panels can achieve a sharp right-angle corner without cracking or damage. This method is ideal for creating clean external and internal corners in wall installations.

Three Steps to Bending SPC Wall Panels at 90 Degrees

1. Grooving

Use a hot air gun to continuously heat along the groove line. The heat softens the SPC’s plastic core, making it flexible enough to bend. Proper heating is essential to ensure the panel can form a perfect 90-degree angle without breaking.

2. Heat Softening

Use a hot air gun to continuously heat along the groove line. The heat softens the SPC’s plastic core, making it flexible enough to bend. Proper heating is essential to ensure the panel can form a perfect 90-degree angle without breaking.

3. Slow Bending to 90°

While applying heat, gradually bend the panel until it reaches a full 90-degree right angle. Keep the pressure even and avoid forcing the bend too quickly, which may cause surface cracking. A step-by-step approach ensures the panel locks into the correct angle and maintains long-term durability.

Additional Notes

It is recommended to watch the instructional video for a clear demonstration of bending SPC wall panels into a 90-degree right angle. During installation, pay attention to safety: avoid overheating or over-bending, as this may damage the panel or weaken its locking system.

Conclusion

SPC wall panels can be bent into precise 90-degree right angles, but only by following the Grooving + Heating + Slow Bending process. This technique is especially useful for forming external and internal corners, ensuring seamless connections while preserving the panel’s strength, waterproofing, and decorative appeal.